Skip to main content
info@traibcert.org.uk UK: +44 7904 664589 UAE: +971 0526 909311

Inspection · During production

During-Production Inspection (DUPRO)

A defect found at 30% of the run is corrected in the next 70%. Found at 100%, it is either shipped or reworked at your expense. During-production inspection, which the old site called production-phase inspection, samples the units already made and the process making them, so the factory fixes the cause and not only the symptom.

Overview

What During-Production Inspection (DUPRO) is

A during-production inspection takes place when 20 to 50% of the order is complete. The inspector samples finished and semi-finished units to the agreed AQL, walks the line to check that in-process controls are being applied, compares the rate of production with the delivery schedule, and identifies any defect that recurs across units and therefore has a process cause.

The output is corrective: a list of defects with their probable causes, agreed with the factory's quality manager on the day, and a re-check point set before the pre-shipment inspection. Buyers who run DUPRO on new suppliers typically see the pre-shipment failure rate fall sharply, because the pre-shipment inspection then confirms rather than discovers.

When to use it

Is this inspection right for your order?

  • New suppliers, new products, or suppliers with a history of pre-shipment failures.
  • Large orders where rework of the whole lot would be prohibitive.
  • Products with a long process chain (cut, sew, finish, assemble, test) where an early-stage error hides until the end.
  • Deadline-driven orders where the production rate needs independent confirmation.

Inspection checklist

What the inspector checks

  • A sample of finished and semi-finished units against specification and approved sample.
  • Recurring defects and their process cause; corrective action agreed with the factory.
  • In-process quality controls: inspection points, records, calibrated gauges and rejected-part handling.
  • Production status: quantity completed against schedule; risk to the delivery date.
  • Packaging and labelling readiness for the pre-shipment stage.

Deliverables

What you receive

A flash report the same day stating whether production is on quality and on schedule, with defects, causes and the corrective actions agreed; the full report follows within two working days, structured so that the pre-shipment inspection can verify each corrective action.

Inspection process

Enquiry → scope and quotation (one working day) → inspection plan and date → inspection → same-day flash report → full report within two working days → release, hold or re-inspection decision.

See the full inspection process

Industries

Who uses this inspection

  • Garment, footwear, furniture, toy and homeware importers.
  • Electrical and electronic goods buyers.
  • Manufacturing supply chains with contract manufacturers.
  • Retail own-brand and marketplace sellers.

FAQs

During-Production Inspection (DUPRO) questions

Why TRAIBCERT

Faster response

A sector specialist replies to every inspection enquiry within one working day with a fixed man-day quotation. Inspections in TRAIBCERT's operating regions are booked within five working days at most locations.

Real-time information

Receive a flash report on the inspection day and the full report within two working days, with daily reports during production monitoring and expediting.

Inspectors who know the product

Inspectors are assigned by product category and discipline, including consumer goods, textiles, electrical, mechanical, welding and NDT, automotive and food. Competence records are kept for each inspector and method.

One body across the UK, the Middle East and India

Inspections use one report format, one point of contact and one quality system across TRAIBCERT's offices and inspector network.